In Abaqus it is possible to define sets. As far as I am informed
you need this sets for creating boundary conditions and defining loads, pressure.
What makes me confused is that you can define a set in "Part"
and on he other hand in "Assembly", where you find the defined set from the Part...
problem:
body X contacts body Y (both iron and rubber on the edge), e.g. rubber on rubber . In visualization it can be seen that body Y go through body X. Contact definition is hard and srface-to-surface.
How can I fix this problem?
thanx for helping
Problem:
a contactproblem between two bodies.
After plotting cpress the curves oscillates.
I think it has sth. to do with the meshing.
with normal meshing the curve looks smooth. But with more finer meshing it looses the smothness.
How can I fix this problem in Abaqus (CAE) ?
many thnax
As far as I am informed Abaqus does not care about units.
After setting the "approximate size" I have noticed that the measurement of the model has the factor 1:100.
For example line A to B has the value 1 (distance "H1"). But I want it to be 100. And not only for this line but for the whole...
While modeling a 2-d human hip joint I need boundary conditions,
One constraint is that the end of the femur is fixed.
How can I define this in Abaqus?
Do I need a reference point?
Many thanx for helping
By modelling a human hip joint (cae ansys/ abaqus) i need to consider loads and
(bound conditions).
One load is the own human weight , which is clear.
But which loads do i have to consider too and where do i have to put them in the geometry?
Many thanx for helping
I want to put a force in x-direction with 10N.
And there is just a reference point given.
How can I write it in the inp-file?
What about the measurement?
there are dload,cload and dsload.But I do not know which of them to use.
After generating the 3d model from 2dax I want the boundary conditions (BC´s) to be carried over too.
How can I write this in the new generated (inp of the 3d-model) input-file?
I have created a 2-d axial-symmetrical model and an input file.
Now I want to generate a 3-d model.How can I fix my problem?
As far as I am informed (in Abaqus CAE) I have to
modify the input file.
What do I have to write in it and where?
thanx for helping
