Can someone explain if the nozzle thickness when connected to a flat plate acc. UG-45(b)(1) should have the thickness of the plate? Isn't a smaller nozzle thickness allowed?
We are having great difficulties getting the tolerance right of M10 holes in cast aluminium plates with M10 thread inserts (make helicoil).
Aluminium type "EN 1706 AC-AlSi7Mg-F" and EN 1706 AC-AlSi7Mg-T6" (F = as cast and T6 = solution treated and artificially aged).
Quality of...
How would the flow rate change (increase or decrease) when for a given pressure (28 bar) and speed (1500 rpm) the oil initially is cold and later temperature increases.
Is it correct that the flow rate decreases when the temperature increases (viscosity drops)?
If so, how can this be...
I'm afraid this might be a silly question but how can I calculate the maximum surface pressure on a (soft) aluminium plate, avoiding an imprint on the surface. In a construction I'm having a rod with in the center a threaded hole. In the Al plate there is a hole through which a bolt connects...
