Hi community,
I've been reading about flange load calculations all over the site (ex: http://www.eng-tips.com/viewthread.cfm?qid=191806), but I have a doubt about the equivalent pressure method used in Autopipe and stated on the Kellogg "Design of piping systems".
The Autopipe software...
Hi everybody,
I've asked some questions regarding steam turbine nozzle strengths and your replies were very useful.
I now have to design a line stop for a SA335-P22 8" NPS that runs 65 barg steam at 530ºC.
Some engineers around say that a we can't use a guide (IPN type welded to the pipe) due...
Hi, everyone.
I have an issue with two different flanges, both are for NPS 1".
The thing is, that for 300# and 600# in the code both have the same dimensions. The 300# flange have the material and rating stamped on it but the other one doesn't.
Is there anyway of knowing for sure if I have a...
Hi everyone.
I'm having some discussions with some colleagues about forces transmitted to static structures linked to pipe supports.
We have a horizontal run of a 30" pipe, with a saddle support welded to it. The base plate of the saddle will be the one in contact with the static structure...
