thread404-305627
So the thread above is closed and last edited 2 years ago but didn't seem to draw any conclusions. I have looked for the answer to this question before to no avail, until now! Hopefully I save someone hours of prowling the internet for this...
Shigley's Mechanical...
Hi,
I have what I thought would be a routine design problem that has turned into a head scratcher. I want to control a ring of 145" diameter by moving it approximately 20 degrees around its centre, it does not move axially. I need to do this with a smaller diameter crank which enables me to...
Hi All,
I have a shaft supported by 3 bearings (we'll consider them simple supports) on the ends and one in the middle. The shaft has 2 masses, one on each side of the middle bearing. The shaft is indeterminate so I replace the middle bearing with a force and set the displacement to 0.
Now...
Hi all,
I am designing a keyway to fit a 7.625" Shaft. I sized the key and keyseat and everything looks good from a stress point of view, however, I am more curious about the positioning of the key.
The key is 1.75" W X 1.5" H and 10" Long with radius equal to half the width of the key on the...
Hello,
I have a problem with SW2009 in Drawing view. When I try to dimension a feature, the little blue selection highlight circles are not appearing. I can dimension the feature, but it will not highlight edges or vertices. Also, when I click an edge, 3 zeros quickly flash and disappear...
Hello,
I am running Hyperstudy for an optimization using Abaqus as a solver. Two questions:
1. Just to make sure when registering my solver script, I point to C:/Abaqus/Commands/abq672se.bat
2. How do I write the script to delay Hyperstudy from continuing my study until Abaqus has actually...
So I have modelled a simple flat bar with 5 plies, I can see my ply stack plot so I know it's modelled correctly. When I analyze it, I use one integration point and specify which to use in my field output. My result is different von Mises stress for each ply at different location, exactly what...
Hello,
I need some help displaying the ply stack plot. Doing just a simple rectangular shell, I defined a carbon fibre material lamina with 8 plies and assigned it to my part. How do I view the ply stack plot? It seems like a useful tool and am interested in using it. I am using version 6.7...
