Looking for a bit of advice, and confirmation that I am on the right path.
I need to take a feed off oil system running at 10 bar, which will pass oil through a couple of devices before being returned to the sump above the oil line. Flow in the branch line to be between 2 and 4 l/min.
I started...
I have a stud with threads at both ends loaded in bending. Should I treat the whole stud as one diameter or reduce the diameter of the threaded parts to the thread minor diameter?
Reducing the diameter at the ends will give localised high stresses.
The stud mufactured using 304 SS bar stock...
My question is this:
If I specify a total runout of 0.05mm on an OD of 6.05 +/-0.05mm, does that mean when it gets inspected by QA the maximum allowable diameter is 6.15mm or 6.1?
This is my first post, hopefully I have the correct forum.
I am trying to fit a sensor that can take a maximum flow rate of 4 l/min into a lubrication system that has a 60 l/min flow. The easiest way I can think to do this is to design a simple manifold and hook the sensor up parallel to the...
