I have a few drawings in Solidworks that the dimension lines have become detached. is there a way to re-attach these lines? from a edge to a centre line?
i know in solidedge i just hold down the alt key and i can attach it anywhere.
I'm working on figuring out a proper methond to calculate the torque for a threaded piston with a nut. this application has a high operating pressure.
I calculated the amount of torque that would be required for the nut without a threaded piston and the amount required for a joint that won't...
i was wondering how i would determine a bolts clamping force, or the amount of tension in the threads when the bolt is screwed into a flange. there is no washer or nut. the bolt is directly screwed into the part.
I need to do some weld calcs for a rod welded to a pin eye using a bevel groove weld all around.
the rod end has a chamfer that has a bevel angle of 30 degrees and a horizontal length of 1/8. i'm treating the pin eye as a flat surface.
i'm comparing the maximum allowable material loads using...
i need to calculate the torque required when fastening a gland into a barrel. (Gland is externally threaded and Barrel tube is internally threaded)
Can i treat this as a joint, where i consider the unthreaded portion of the barrel contacting the gland shoulder a washer?
gland material is...
I need to figure out the throat area for a weld on a 1.5" rod welded to a pin eye. the weld type is bevel groove.
i am using this formula but it doesn't seem right to me:
A = pi/4 * [(Do-Di)/cos(chamfer angle)]
can someone tell me if this is correct or another formula.
thanks in advance.
