Hello all,
We have a new drilling system, after waiting forever it seems on suppliers to get their lazy arses into gear, we finally have one. It is a Mapal unit, in 21,50mm diameter.
Now we require a single blade type reamer to go with the high speed / high penetration rates we need for...
Hello all,
We are in the process of manufacturing rifle actions. The firing pin of said actions is driven by a belleville washer stack, rather than the typical helical spring.
We are looking for belleville washers in titanium, but are having some trouble finding them. Any ideas?
Size: 6,2 x...
Hello,
Done a search for surface treatment options, but not found anything. We are making rifle actions, and need a surface treatment for the bolt body. So far, hard chrome plating has been used, but there are a few small design changes that make the HCP less desirable now - such as easier chip...
Hello all,
I will soon need to do some deep hole drilling for a job we have on. It involves a hole drilled into 35ncd16 steel (annealed condition), to about 180mm deep, likely a blind hole, but yet to be seen how the job will be chucked up.
We have a Mazak SQT15MS, and the job will be done on...
Hello all,
I am about to embark on a new manufacturing endeavour, and would like the help and advice of knowlegeable members:
I will be building rifle actions. I have all of the materials specified by the designer/metalurgist. The main body is plain 4140 in pre-hardened state, post ionic...
