This is about compressor and its motor shaft alignments.
Usually compressor manufacturers put motor and compressor shafts in the same horizontal elevations, is there any specific reason for that?
If the motor's shaft is higher or lower, still its alignment with compressor's shaft can lie in a...
Hi Guys,
I am looking for the definition of "Sutface Finish No. 5".
What standard is it based on?
and
How can I measure or verify it on a piece?
Thanks in advance,
:)
Guys,
I have lost all AutoCAD SHX fonts in the Multiline Text Editor. It does not recognize any of SHX fonts and does not show them in the Font drop down list. Do you know what the problem is?
:)
Farzad
Hi guys,
I need to know if there is any method or a small program or routine to lock a dwg such that noone can edit entities or copy and paste objects. Only zoom, pan, plot and viewing commands can be run.
Thanks[thumbsup2]
FH
I need to know about a process for leveling and blanking a plate with thickness of about 1.5 mm.
We use plates in roll-forming for outer body of buses. Unfortunately the plates we use are not flat in both directions.
Does anybody know about some references or mechanisms to solve the a.m...
Hi guys,
When you shade a model using the SHADEMODE command, some objects like Regions and Bodies (and surfaces in MDT) cannot be seen from both sides, and they are visible just in one side.
To solve this problem you should enter the OPTIONS command and activate the "System" tab in...
Hi everybody,
Is there any way to change the input character in Word?
I need to redirect the keyboard so that every time I press the 'D' key on keyboard, the 'Shift + X' character typed in Word document.
Any macro?
Any prompt reply would be highly appreciated.
:)
Farzad
