This has probably been posted a hundred times but I'm going to pose the question regardless. Does anyone know if there is an online calculator to figure the amount of volume moved within a certain inside diameter/length at a given psi in sec or min?...including a given viscosity and temp?
Anyone know of some info I could look over regarding an electrical switch that would lock under a little stress but would need to be capable of holding a very heavy load (not an electrical load but pressurized/weight load)...it would need to release under the heavy load as well. The rod it...
Anyone know of any linear actuators out there that are capable of a 50lb - 100lb full load with a stroke of 3" - 10" and a travel speed of 33" per second or greater (with applied full load)? The catch is that it has to be 12vdc with as small of an amp requirement as possible. Thank you for any...
I have a design that would solve a hindering problem if I could simply charge one end of an actuator with about 200 psi of oil and not tie it into a circulating system. My question is would it heat up too much in doing this? The other end of the actuator is going to fluctuate from about 200...
Anyone have any knowledge about transfering a pressurized cryogen gas between two tanks...one insulated and the other is not (both are equal in volume). Both tanks must maintain a pressure through the transfer, which tanks are side by side and an insulated line connecting the two is less than a...
Anyone have any experience with Bi-2223/Ag tape coils? I'm new to the whole HTS tape process. Flexibilty sounds like a big issue as the tape seems to be a little on the fragile side. Racetrack coils seem to be for larger applications and seem to be quite a process with layering and epoxy...
