I am designing sheet metal part, it has an internal cutout with .25 edge flange all around it. Is it ok to create my custom bend relief - picture attached - or should I stick to SW custom relief type in edge flange feature? Those look rather strange for this application and I like that my own...
not sure if this is the correct forum to put this - is there a table referring to countersink dimensions? specifically I am after 90 deg countersink for 1/4. your tips will be greatly appreciated. thank you
I recently came across the drawing with 2 decimal tolerance on 3 decimal dimension, eg: .567 +/-.01,it is a machine part, I can't see the logic having 2 decimal tolerance here, am I missing something? (the tolerances specified on drawing are .XX +/-.05 and .XXX +/-.005), thank you for your input
Anybody knows about latch that would serve as a hold open device? Needs to be mounted on .25 panel. Or any tips for companies that sell some?
Thanks a lot for your tips!
I am trying to find very small zee extrusion (overall width .2) to go on .1 lexan, does anybody know about any Boeing extrusion? (I checked BAC1520, but everything was too wide),
I am new to this site, so I appologize if this question is not what it should be...
thank you so much for any tips
