Is there an alternate way of selecting all the interior/exterior surfaces of model then manually selecting them? I know other fea packages would had ways of doing this. Boxing in helps a little but not to much when you have most of surfaces selected.
As I understand it there are basically two methods or processes to do Electroless Nickel Plating. The end results are the same but the process to get there it what is different. One process requires more prep work and uses more environmentally friendly chemicals the other is less work but uses...
I'm looking coatings to protect aluminum (380 cast aluminum) from wear and corrosion from chlorine bleach, ammonia, industrial cleaners, tap water, and effluent.
I have looked at electro-less nickel and the cost is on the high side, what other alternatives are there?
How do you manually reorder the items in an assembly? And how do you reorder it in the BOM on a drawing, if it's not as you would like. I am using NX6. I am a long time I-deas user so it's a bit a change.
TIA
