What are the nuances to the terms principal/principle (I don't know which is supposed to be the proper spelling, but I have seen both) engineer vs lead engineer vs engineer?
Hello,
I am trying to save a drawing file as a pdf form using the add in in Solidworks. Unfortunately, it cuts off the edges of the document. Can someone share a quick solution to this problem?
Thanks
Hello,
I am trying to model a constant strain rate test. My model is very simple block with the bottom area held constant and a load placed on the top area. I tried a constant displacement load but it changes the strain rate considerably over the loading time- which is understandable- but...
Hello,
I would like to run a set of independent input files in ANSYS consecutively. Can anyone explain how to do this? I found the help in the Ansys manual a little confusing.
Thanks for your help,
Debbie
Hello,
I am trying to perform a CTE mismatch analysis. I am trying to figure out which command to use to apply a higher temperature to the entire model (i.e. what happens when an oven and specimen reacha steady state temperature). I want to see the displacement caused by the temperature load...
Hello,
I am trying to draw a machine drawing of a three dimensional object using Autocad R13.
Is there a way to draw lines with a hidden linetype in one viewport but not in another?
Thank you
