Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: iv2jm
  • Content: Threads
  • Order by date
  1. iv2jm

    Hypoid Gear Pressure Angles

    Hey Folks, There seems to be lots of scattered information about hypoid gearsets and I'm trying to grasp some basic understanding. I'm using equations from the Timken website (attached) to resolve gear forces back to bearing support loads. They don't relate the tangential forces to the...
  2. iv2jm

    Membrane Stress- What is it?

    Hey folks, I'm curious what a membrane stress is, and if it's pertinent to tubular beam sections analyzed by shells. It's not something I remember from and classes and seems like its more relevant to pressure vessels. May case involves a swing arm constructed from bent and welded sheet...
  3. iv2jm

    SW 2007 Toolbox BOM relation

    Hey Folks, I realize similar topics have been posted but I could not find something specifically helpful... I appreciate your patience. Similar to others, I would like to bring in configuration specific data to BOMs for toolbox hardware. I can (tediously) set up the database to apply a Part...
  4. iv2jm

    Imaginary Feature Datum

    We just designed a part with a patterned hole pattern. Basically, a small hole pattern of 4 holes in a square is patterned 3 times around a circle for 3 linear bearings. the center point of the pattern of 3 has a vertical centerline called out as Datum B and the horizontal centerline called...
  5. iv2jm

    Centerline/ Symmetry

    Hey Guys, I came across an interesting issue. Angles that appear 90 degrees are assumed right angles unless otherwise marked- are centerlines assumed to designate symmetry across a a feature with flat sides? IE, a keyway or hex pattern for wrench. I have a shaft with a keyway at 22.5 degrees...

Part and Inventory Search

Back
Top