Can anyone help clear up some confusion I have over the suitability of 2014 T6 and 7075 T6 for anodising.
I have heard that 7075 T6 can become brittle and therefore fatigue performance is reduced when anodised or hard anodised. Conversely when browsing anodisers web sites I have noticed that...
Does anyone know the formula or process for relating bolt tension to the nominal internal pressure when clamping a bore to a shaft using a pinch bolt.
I have looked through text books and can't seem to get the relationship to work. There must be a way of relating the bolt tension to hoop...
I am setting up a test rig to measure stiffness of a motorcycle chassis and require a method of accurately sensing the load applied. Load is applied via a hydraulic cylinder, I have a pressure guage but the cylinder capacity is 45kN of which I am using typically upto 2.5 kN. I feel that the...
A question from a friend of mine. 'Should the roll center of the 1969 Pontiac GTO
race car be above or below the ground ? currently 500mm below ground with
factory set-up, and under 75mm bump the front camber goes from -3deg to
+1deg'
In my opinion. Large offset between C of G and Roll...
