Our company lines pipe and it gets spinned to the inside of the pipe including the bell end of the pipe - does anyone know of a way to seal off the bell end of pipe so that does not occur?
Where I work, we coat pipe all the way down and then remove the last 6 or so inches of coating after it was coated. This is done on an assembly line fashion and the coating is applied while the pipe spins and the coating gets thrown against the inside of the pipe usng centrifigal force.
What...
we are looking for a pipe stop which will stop pipe rolling down a rail. This pipe stop will have to move out of the way for th epipe to roll by after rail is full - anyone out ther use anything
can you purge molton iron with 99.9% nitrogen without getting impurities - looking at getting an onsite system to be main supply with liquid nitrogen tank as backup?
I run round stock in various diameters going through the oven horizontally rolling down being pushed by a chain conveyor with peridic ss rods that stick up into the furnace and when then rolling stock runs over it, it depreeses the rod and activates the switch. That is way it is suppose to work...
