Hi all, I'd like your opinion on a certain system where 4 cylinders are to be synchrod within ± 0.5mm
Stroke is 10-150mm the stroke has a ±90 minute duration iow the 4 cylinders will have to extend lets say 150mm over the course of 90 minutes.
Initial design is to be closed loop with vickers...
Hi everyone, I am currently having problems with mechanical seal failures on two Aurora Series 421 - Horizontal Multi Stage Split Case Pumps.
Sync speed of 3600RPM, ± 1000gpm
Size: 6x6 with an Impeller 11.315 trimmed down to 11.25in
by dealer in order to reduce amp draw
I would like to...
Hi all, my students asked me why some pisons in carbiable piston pump motors and pumps are hollow, and why others are full.???
I have a couple of ideas why, but I'like input on this as some people have mentioned its just the way it is, but I honestly think that manufacturers won't spend extra...
Hi all, Could anyone familiar with these valves (Hytos in this case) help me figure out why the following happens: I have a hydraulic circuit where the principal components are: pump, Hytos proportional directional valve with closed center, a sequence valve which will actuate a cylinder (on...
