Hi everybody;
Please, could anybody tell me a device to measure the quality of the vapour?
Reading literature, I found a device that throttles a portion of mass flow. The philosophy consists in the measure of the throttled mass flow (isoentalphic throttling)in order to know the quality of the...
Hi everybody;
I´m project engineer and I´m entirely involved in a heat recovery project. I´m defining a condenser, and I would like to know a software to simulate its performance in order to define it.
So please, could anybody tell me a program, software...??
My intention is to use a plate heat...
Hi everybody;
Could anybody tell me a link, guide, manual or something useful related to the piping design in Organic Rankine cycles? Piping design in conventional Rankine cycles could be useful as well.
Thanks
Hi everybody!!!
I´m project engineer and I´m working in a Rankine cycle project. We are in the state of the project related to the pump definition. My question is, could anybody tell me a list of the best centrifugal pumps manufacturers?
Thank you very much
Hi everybody. I´m project engineer working in a new project. Our intention is to recover thermal power from the cooling circuit of an engine. We are going to set up a 3 ways valve in the outlet of the engine (instead of termostates) to maintain 90 ºC in the heat exchangers inlet. The temperature...
Hi everybody. I´m project engineer from Spain. I´m workig in a rankine cycle project and we are in the state of the project related to the pipes design. We have some doubts:
If we reduce the mass flow, what happens with the pressure? (I think it drops, but I don´t know why). our intention is to...
Hi everybody!
I´m project engineer from Spain. I´m working in a new Rankine cycle project and I´m looking for a heat exchanger (condenser).
The conditions are different depending on the season, that is;
Summer conditions: P= 2 bar, Temperature from 50ºC (inlet) to 33ºC (outlet)
Winter...
Hi everybody!
I´m project engineer. We are working in a new ORC (Organic RAnkine Cycle) project and our porpouse is to recover thermal power from a low temperature source. The inlet conditios in the expander (is not defined yet) are: T=82ºC and P=8,3 bar. The oulet conditions are different...
