All, I accidentally posted this problem while inside "ANSI B31.3 Rule of Thumb" thread. I apologize for this. So this is the proper place - and to start again: I have run a model 150 psig/370 deg F Steam @ 8" nom. diam. which ties-in axially to a 12" existing steam header...
Sometimes back I encountered a pipe stress model that generated one of the highest at 95% of the allowable on operating load case. I was then a bit worry of the closeness to the maximum allowable limit untill somebody told me that it is okey. Technically it is stil within the allowable and is...
I don't have much experience on plate type heat exhanger. Other than it could be upgraded easily by adding plates, could anybody around have any working knowledge on its "main advantage" compared to the shell and tube heat exchanger? Maybe worth mentioning are cooling and heating...
I am requested to research from anybody around who knows any gas flow software - a program that could calculate masss flowrate, pressure drops, etc. It hs been emphasized that the gas flow application would be on scrubb exhaust gas for microelectronics application. This is acidic in nature and...
After reading all the issue regarding pipe stress analysis, I have this guts to ask help from those expert on the subject. I am going to perform a stress analysis on a 12" line, 400 psi/450 deg F with the layout not known to me yet other than it is a line interconnecting two skids, one with...
Hi to everyone,
I'm a new member and this is my first attempt to ask help from anybody around familiar with the subject. May I ask anybody familiar with piping material specification for PVDF, PE,PP and PVC/CPVC pipe where to obtain their physical properties as allowable stress, modulus of...
