Hi Colleagues:
It is a habit to put lifting lugs in head knuckle but unfortunatelly it is so difficult (almost impossible) to find example works related to how determine stress in this zone. Could anyone explain me how to perform this calcs without using FEM? I would be very appreciated...
Dear Colleagues:
At this moment , i'm designing a tank using European standard to perform all calcs. But when I try to obtain results for conical course with apex angle equal to 30 or less.
The exactly problem is to find an method using referred codes to determine requires thickness in...
Dear Colleagues:
I have checked for a Cinch to lift a equipment using 2 of this type. We have checked critical points and we know very well the responsibility of kind of lifting. Problem to me at this point, I try to evaluate using Moss pag 416 (transp and erection ....)but unfortunatelly we...
Dear Colleagues:
It may seem a bit strange matter I'm talking about but would like to have your cooperation in the field.
I wonder, if possible, a method "analytic" not by FEM to determine the effect of nozzle external loads on the flat wall of a rectangular tank. This tank is full of any...
Dear Colleagues:
Have anyone experience in this kind of calculation? avoid, of course, finite element method?. Design by formules will be more appreciated than FEM. Zick method appears not applicable to this situation but WRC Method are not suitable.
Please, help me to find an adequated...
Dear Colleagues:
At this moment ,I have to design an equipment that resist an explosion load in its internal part. Does anyone knows any information related to this matter?
Thanks in advanced.
Luike
Dear colleages:
At this moment, i'm making an elbow thickness calculation.
Material carbon steel, pressure 6 barg , NPS 10 inch, this data is only for reference not relevant.
I don't wanna use shell calculation because i consider that it should be corrected using radius of curvature, etc. I...
Dear Coleagues:
At this moment, i'm designing a metallic structure for to support a milling machine in more remote extreme, it deals a cantilever reinforcement beam. It will be 4 meter longer
and it will be attached to a fundation in the other extreme.
The point, in this kind of attached...
Dear Coleagues:
At this moment, I need to perform a thermal design of a finned tube bundle (with half pipe headers), it means, to introduce it in a high diameter pipe (between special cones for to suit it) from digestor plan outlet and make use of outlet gases for to
heat fresh water in a...
Dear colleagues:
Simillar to past thread related to 93%, i'm in a simillar case but with higher concentration. I must design a tank for this kind of content and i'm thinking to use standard carbon steel (A-516-60)as material. I was reading about their effect upon carbon steel and the...
Dear Coleagues:
I'm a begginer in this kind of forum but i need a specific
help.
I'm checking effect due supports in equipment but this one have 3 support. I've calculated loads and moments due to weigth on each support using 3 moments methods (this equipments is almost simmetric, no changes...
Dear Coleagues:
It is my first time in this forum, I'm a begginer in this field but I need , due to job requirements, to clarify a doubt in order to establish equation for piping (with accessories as bends, elbows, etc).
In my proper special case, I've a piping just at pump discharge zone...
