Hi all,
Our company is currently reviewing its software across all its european offices in an exercise to decide on a single platform
The two in the running seem to be Microstation and PDMS. Neither of which I have any experience!
Therefore any advice/opinions would be warmly recieved.
We...
Hi!
We currently use paper checklist and red pen method to mark up drawings.
Does anyone use the markup system within ACAD? If so reflections, limitations, learing points, implimentation advice...
All greatfully recieved
Scott
Dear material people,
We have ordered a carbon steel vessel with weld overlayed in inconel 625 and we have been asked by our client to ensure that the material does not exceed 200BHN.
Should this pose any problem??
Our fabricator is asking for us to request a concession on the hardness...
Hi all,
We are subcontracting design and manufacture of a pressure vessel and the initial drawings from our subcontractor are showing the hemi-head butting directly onto the tan line of the vessel.
Question 1: Is taper allowed to be constructed of weld build up?
We questioned this, as it was...
Just want to pick the collective brains.
We are currently in design phase for some internals to be installed into a Inconel 625 weld overlayed vessel (gas scrubber service). Our intenals are typically 316l, bolted with A4 grade 316 bolting.
Are we ok to use the A4 bolting direct to the Inconel...
