Where can I find sizing procedure for vent stack diameter and height determination. I have my max blowdow rate at 1,500,000 lb/hr (799 MMscfd). Thanks.
.
If your water pipeline is designed for slack flow with no air release or vacuum breaker, and you start with a fixed amonut of dissolved air in your water at pump suction, pump it through the pipeline (hilly)and then discharge it to the same pressure as source pressure (pump suction pressure...
I have a pump system, which may go into 100% recycle for many hours. I would like to calculate what the tank temperature will be after 10 hours. At time = 0 T= 120 F, tank volume = 5000 gallon, cp = 1.0 Btu/lb/F, the recycle flowrate = 5 gpm.
I have a water sump with a sump pump. The flowrate into the sump is variable. The pump has a VFD. There is a feed back loop with a FCV in it(this is to maintain min flow for the pump).
There are 3 signals going to the FIC, which controls the FCV. They are the sump LCV (tied to the VFD), the...
I have a water pipeline (several miles with hilly terrain), which takes treated water from a sump pump and dumps it into a separator for venting off the air, the water from there goes through a diffuser into a river. I have air release valves on the hill tops. The line is 16" ANSI 150...
I have an atmospheric water sump tank with a pump. I need to pump the water out to a river through several miles of pipe. I need to add an air/water separator in the line before it reaches the river, so that all the entrained air can come off before water enters the river. The pipeline goes...
My gas stream is 98% co2, it has 0.46% c1, 1.1% c2, 0.06% h2s, 0.049% argon, 0.063% o2, 0.46% n2. It is the flue gas from amine stripper. I need to compress it to 2000 psig, the flowarte is about 1.8 MMscfd, and transfer it into a pipeline.
What method of dehydration do I need?
What type of...
