Trying to figure out the purpose of this. My 1992 BMW does not have this resistor on the car or in the schematic. My 1995 engine does. I am hunting down ignition coil noise and I want to figure out whether this is a good thing to implement or not.
The resistor is 240 ohm, 2-watts. I doubt...
Hi all,
Recently my car developed an issue. Recent as in a couple or few months but I finally have the time to sit down and look at it. I had issues with my hall effect crank position sensor sync'ing up according to the DTA ECU I run. It would take longer than normal to crank over. I hooked...
Hi all -
Considering re-wiring much of my custom wiring loom on my BMW. I can't find a good resource that sells many colors of wire. McMaster Carr has like 8 or 9 colors and that's nice but I was hoping for like basic colors + stripes and such so I can pin out an 80 pin connector with...
Hello all greetings
I am converting an engine from using VR sensors to Hall sensors. I have the proper sensor which is a fully threaded aluminum housing that will go into where the former VR bosch sensor mounted (with a tab to hold the old sensor down). The part I machined is like the old...
