Hi I am planning to design a sludge pump.
Would just like to know that is there any limitation in the sludge operational hours?
Tried to look for more information on it but din't really came up with anything...
Should I use the operational hours as a basis of my calculation for my pump...
Currently I'm designing an open flow channel to enable fix flow rates through the channel. Currently I have the width of the screen/channel, but the problem arise because I cant determine the water depth that the water need to pass through the screen. I've tried various ways to find them and the...
I'm currently designing a separator which is used to remove excess air from saturated water after passing through a saturation tank. From thread124-155681 i saw some information that is usefull for my design but I'm not too sure about the level controller design.
1)How do I know at which point...
Currently I am designing a open flow channel flowing through a screen which is installed at an angle of 70 degrees in the open channel. I have my discharge rate, and the width of the channel. Is there any possible ways that I can estimate the height/depth of the water without knowing the velocity?
I'm currently doing a design for a liquid gas separator. I would like to determine how to install my control valves, typically level controls. But I'm not too sure about the pressure drop when the valve is opened, therefore I do not know how to design my liquid depth and the maximum and minimum...
