Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: JsTyLz
  • Content: Threads
  • Order by date
  1. JsTyLz

    How to call out staking on a print

    A ground pin is slip fit through a housing into another housing. These housing are to rotate about each other, and neither is fixed (only when in a locked state are they fixed). The pin allows them to move when the mechanism in unlocked. Question is that on the print there is a callout for...
  2. JsTyLz

    ASME Y14.5-1994 Assumed 90 degree angle on the print

    Under the ASME Y14.5-1994 - Is there anything relating the appearance of all right angles as 90 degrees. I have been told that you must assume that all right angles are 90 degrees. 1. Is it true under the ASME standard I posted? 2. Furthermore, do you assume the title block tolerance on that...
  3. JsTyLz

    Lazy designers/drafters

    I am not saying all designers or drafters are lazy, but for me it is like pulling teeth to get one of them to work. Of course I always get the project done in time, and in all honesty I generally expect more out of people than what they do themselves. I am just wondering how many other engineers...
  4. JsTyLz

    Torque on a nut and relation to axial force?

    Torque on a nut and relation to axial force? In relation to the torque, how can one calculate the resultant axial load. I was looking at the same calculation used for a worm gear, but have also seen some examples in the Machinery's Hand Book. Also crucial to the design is that the nut has a...
  5. JsTyLz

    Electronic Stability Control - Good or Bad (or Ugly???)

    In another post ESC came up and I am wondering how much it is affecting the the roll stiffness, if any? I assume none. I think the control is affected by the the self centering feel you gat from the steering column. If there is steering assist, then at low speeds the steering is loose, and at...

Part and Inventory Search

Back
Top