I've had several idea's about how to secure a small Supercharger rotor to the shaft that I'm building. Rather than a conventional press fit & parallel shaft I was thinking to use a Taper of 1 degree, but I'm open to suggestions.
The Rotors are 6061 Al, OD 75mm, Length 150mm.
The Shaft is 4140...
Hi All
I found a macro for an Involute curve that works great however I see that the created curve in the sketch is a series of points & lines. I converted this Inv curve to construction geometry and recreated the Inv Curve with a Spline along the points that looks better.
My question is whats...
Hi,
I have a small Heat bench that I put together to test a few small M/C Radiators, at the moment its set up to suck air through the Radiator. I'm measuring the Depression with a water manometer between the Fan and the Rad for each test... e.g. lets say its 20mm H2O @ 8m/sec
Now if I change...
Hi
I'm confused here about the curve through the xyz points as I cant seem to get it to import the plotted curves, I have a bunch of coordinates from a CMM and these have been saved into 3 columns as the help file on this topic suggests.
here is a curve that wont open.
0.00 46.90 131.95
42.18...
Hi
I'm new to these forums and what a great wealth of information reside here.
My question is with regards to Lofting a Y Duct like the sort thats used in HVAC, I can draw this with 3 circles located on 3 planes and extrude this but How about the loft feature is this possible ? I had 3 guide...
