Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: LTRN
  • Content: Threads
  • Order by date
  1. LTRN

    Stress relief

    Will stress relief help minimize preferential weld corrosion of mild steel welds in acidic service?
  2. LTRN

    material exposed to excessive heat

    I am interested in evaluating an ASME Sec.8 Div.1 vessel that was exposed to excessive temp. The vessel is 60 inch ID X 96 inch lenght, .186 inch wall Sa-36 shell with .375 inch wall flange and dish Sa-516 gr70 heads. The design conditions are 40 PSI @ 650°F. The lower portion ( approx.18 inches...
  3. LTRN

    Fiberglass Flange Torque Values ?

    I am interested in a source/standard that can provide torque values for fiberglass and furan type flanges. All help much appreciated.
  4. LTRN

    Wind load calculation

    I need to perform a calculation for minimum wall thickness required, in terms of wind load for a simple vent stack. I am interested in the proper formula and any additional comments as well. Thank You. Stack dimensions 36 inch diameter 90 feet height .375 nominal 100 MPH wind
  5. LTRN

    Charpy testing required ?

    Is impacting testing required for a repair organizations WPS/PQR regarding the following application ?¿» ASME Sec.8 Div.1 vessel Nameplate -75º top section of vessel -55º mid secton of vessel Material SA516-70 with monel clad ( not sure if normalized) Wall thickness = .500" + 10%...

Part and Inventory Search

Back
Top Bottom