I'm not sure if this is the best forum to pose this question, but since it does impact a note on a drawing I'll ask it here.
The company that I am at now is not accustomed to having sheet metal parts physically marked by any methods. I am from a background of commercial, semiconductor, and...
I am currently in the process of updating an older drawing, and it has an internal thread callout of M7 x .75-6H. Under the thread callout it also calls out the minimum Major Diameter, Pitch Diameter limits, and Minor Diameter limits. It's designated according to section 7.6 Designaton of...
I have a dimension .004 X 45 degrees created with the CHAMFER DIMENSION command. I used the Callout Perpendicular under the Properties. It pulls a leader off with the chamfer dimension. Is it possible to add a vertex to the leader now? I know you can do it with leaders by using the ALT key while...
