Hello,
I try to simulate simple contact models in explicit solver.
My model:
1. Rigid flat surface(400*400 mm). Solid cube (100*100*100) drops(with 4000 mm/sec) on rigid surface. I have specified general contact. In my case dropping solid does not make any contact with rigid surface and...
Hello,
I analyze a part with rigid (fixed in all 6 dof) boundary conditions. But in reality, there will be some translational movement(3 directions), say around 1 mm. Is it possible to simulate this condition. How to specify. My solver is abaqus.
Thanks for your time.
fembig
Hello,
For meshing, i make midplane surface model out of my 3d model. During the process, i get very small surfaces, which i join with other surfaces. But join operation does not remove my small surface edges. So, in meshing i need to have very small elements to have better quality in these...
Hello,
For a glass filled nylon part, we have to do fem analysis using abaqus(probably). I have material datas like all modulus, possion ratio, stress-strain curve(tensile) etc.,
Design objective would be under high load, created stress should be in the elastic range. Anything beyond is...
