NSCS Guidance, 10.1 states that the permitted deviation (Δ) are generally twice the deviation, as the values are given as both plus and minus numbers, except where separate plus or minus values are given.
EN 13670, 3.13 deifines permitted deviation (Δ) as the permitted algebraic differences...
How can I merge the nodes of coplanar and geometrically unique faces inorder to give me a smooth stress contour at the interface.
My model in workbench environment is supposed to be only one simple part but since I need to apply the loads on a particular portion on a face, I sliced it into two...
Does this work in WB?
All I just need from you guys is to tell me whether I am doing nonsense here or if otherwise—I just need to learn how to do it.
I have an assembly in WB of 7 parts (every part with defined contacts, some are auto-assigned, some I simplified by taking away unused surfaces)...
Haven't anyone yet come accross AutoCAD's (or Autolisp) capability on calculating the torsional constant of a section in AutoCAD?
The same question has been raised by Sutki1 (thread555-173004)six months ago. Any Developements since then?
Thanks,
Larry
I would like to show the maximum stresses and deflection of each part of my simulation assembly in Workbench10.
I tried to select the part I need to investigate and hide/disable all other parts but the stresses bar is still showing me the maximum stress of the entire assembly. I need to see...
I am analysing a base plate which I want the bearing surface to be active only under compression.
I tried to use surface effect (SURF154) and specified the foundation stiffness (EFS) and set the surface tension (SURT) to a very small value. To test whether it works as a compression only, I...
