On Mike's suggestion, I have asked admin of the forum to delete the thread. But we can discuss that here
Desert forx post
"What grade of bolt is it ie whats its proof load? img511 and 514 don't work.
I assume the bolts are in tapped holes?
Could be a number of things like you have already...
Is any one here very good at reviewing the solid lubricant spec sheets? If yes, I can past couple of pages here and you can leave comments if we spec that out right or not, or if we need to do any changes.
All I request is to just review our spec sheet and tell me if we are doing it right.
This is the new problem I am working on, on one of the mounting bolts. This time I will try my level best to give you guys as much of info as possible with pictures. This is our major issue (Customer satisfaction)
Problem where find: In the field, somewhere between 5hr to 440hr of engine run in...
Hi
I am new to this forum, but used to be in ROM (Read only mode). I am new to the fastening field but have quite a bit knowledge. My problem is we are yielding some bearing bolts right after installation on the cylinder block and crank case joint. I will provide you guys the info on bolt and...
