Hi Folks
Has anybody imported a part using scale in NX11. I've reported a problem to GTAC back in October 2016 (PR#7862496) which was able to be repeated at Siemens. Yesterday I get email from Software Engineering and they say it "WORKS AS DESIGNED". Well if anyone tries it you'll see it is...
Hello
okay .. I been you the moldwizard stock size and have always oriented my WCS to the block and it gives me the correct size. All of a sudden, the default dynamic WCS comes up relative to abs. wcs and I have to reorient WCS again to get proper stock size. It's only on the part I am...
I am trying to use NX9 and the surfaces I create display 2 different colors which depending upon which side of the surface you are looking at. How do I turn this off? Thanks, Brian
Hi, I am just moving up to nx8 from 7.5 and for some reason when I do edge fillets, It goes through updating through the hole model and reports warnings from previous features. Is there something new in nx8 causing this. Isn't this time stamped?
Thanks, Brian
