Hi guys, I dont know if you can answer my question or show me a website that can.. I am designing a bracket to withstand a load of 2400kg. The bracket will allow the load to rotate from a upright position to a flat position, much like a letter box but upside-down..What I want to know is where...
Hi guys,
Can anyone tell me the design stress of Lead please?
I have been tasked to design a radiation flap and I intend to make the inner layer from a Lead plate. I have found the density of Lead to work out the mass now I need to find out the Design Stress of Lead I am working at Ambient...
Good day everybody...
I am a design engineer working for a company that manufactures expansion bellows units, I have received an enquiry for Hot Blast Main bellows for a furnace. the inlet side of the unit will have standard ASA flanges while the outlet side they have specified using water...
Good day everyone,
I have the need to source some non-metallic pipe/tubing that can withstand pressures of up to 7.5bar and temperatues of 170C. I have had experience with rubber and know of products that withstand 130C but not for long periods. Could someone advise on a material I can use...
Hi guys,
I have a question, in my company we make bellows, we test the bellows to a standard test pressure of 1.5 times the design pressure. I was reading some of EJMA the expansion joints manufacturers association stds book and a paragraph confused me. When testing products with an extremely...
Hi guys..
I have a part I need to design yet I cannot tell what material it is by the designation. The other materials were written as z6 CNT 18-11 which I have found to be stainless steel grade 321, yet the flange material is stated as either Z5 or S5 CD4 S.... I can't find any equivalents on...
Hello, I'm a newbie to this site.. I am a design engineer involved with pipework and bellows design, I am designing a unit called a hinged unit, you may have heard you may not. but.. i have a question of stress! i have a pressure end load acting on the unit to restrain this I must use plates and...
