Hi, Not sure if this is the right forum for pneumatics, but it was the closest I could find on this site.
I'm trying to source out a Proportional Rotary actuator, but all I can find for rotary actuators is fully closed or fully open actuation and nothing in between.
There are some like the...
I have a frame made out of 5"X4"X3/16" HSS. I want to run some load analysis and I want to compare the strenght results if the top X beam is HSS or an Angle beam (all other beams will be HSS). For this analysis, you need to use the beam mesh, but how does the beam mesh know if the X beam is...
I wasn't sure how to edit my post and move it to the right place, so I'm re-posting it in the right place instead. If an administrator could erase the original from the Structural->other thread. Thanks,
I'm using solidworks/cosmosworks to model a structural frame that's made up of structural...
I have a 24" dia x 22" long cyclindrical aluminum tank 1/4" thick. This tank is filled with diesel fuel. I need to place this tank inside a reactangular (26"x26"x16"high) aluminum tank 1/4" thick that will be filled with water. The water tank (rectangular) will have an inlet and an outlet to...
I'm doing a FEA model of stresses in a plate. The plate ASTM A36 steel and dimensions are 140" x 250" x 0.25" thick. The plate is restrained along all 4 0.25" edges. The bottom side has stiffeners that are 0.125" thick and also A36 material and are spaced every 16". The stiffeners are "L"...
Hello,
I have a 30Amp 24VDC power supply. The power input to the power supply is 480VAC and the output from the power supply is 24VDC. I want to put a 3-phase circuit breaker before the power supply, but I'm having a hard time sizing the circuit breaker. Is there a formula that I can use for...
