So the jist of the issue is that I am using a 1 oz. trace, approximately 7 thousandths wide and .5" long to supply a very short, high current (150A to sometimes 500A, 1V or less) pulse to a reactive multilayer to start a reaction. The problem is that sometimes, the trace "blows", charring...
If you have, please let me know because I am having a hard time getting it to work via PC. In addition, the software supplied with it appears to be a bad image. To make matters worse, Sony Industrial died 5 years ago, which means this product has no support from Sony at all. Any help would be...
ok, so i have two curved profiles that I'd like to loft together to make what i can only describe as a chunk of a football in the end. I have a JPEG of the two profiles and the guide profiles on the existing part below.
I am getting errors saying "all profiles must be closed", "all profiles...
Alright fellas,
you guys have helped out a ton in the past on a variety of subjects. Today I'm wondering if any of you have experience in failure analysis or reliability testing of these specific LED's. I am qualifying them right now and was wondering if you could answer a few Q's:
1.) i use...
so i have this cylindrical part that i want to add a thread to. I did a search in the help file and found out about a bolt command, but cannot find it in the software. Is this a special package?? Also, i noticed i can do camshafts as well with a special wizard. I couldn't find that one...
So I have this crazy lookin polygon thing that i drew in 3d space. However, when i try to extrude the face, it doesn't work. I am trying to subtract it from another three dimensional solid and i've been stuck at this point for a while.
Any recommendations??
what's happening, guys?
i have a rather annoying issue to deal with. i am trying to selectively solder onto a completely gold metallized surface with AgSn or SAC solder. I have tried all different kinds of solder masks and tapes, but the adhesives breakdown at these RoHS reflow temps. Aside...
Hey guys. I'm trying to find a commercially available thermal test vehicle with built in temperature monitoring to test thermal interface solutions. I need something fairly high power, like 100W minimum over a 20mm x 20mm area. Is there anything out there? All I have been able to find are...
Hey guys. I am a newcomer to this forum. I am trying to get fully cured or even B-stage ultra high molecular weight polyethylene to fuse to itself with the use of localized heat. I'm just wondering if there is a resource out there that goes over different thermal profiles used in post-process...
