Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: dodson
  • Content: Threads
  • Order by date
  1. dodson

    Washer Requirement for Bolted Bearing Connection?

    I have a project with wide flange girders, wide flange joists at ~8' oc supporting a 5" deck with slab. For the joist to girder connections I have a standard double angle bolted connection. The fabricator used short slotted holes in all of the angles. He used washers on the nut side of the bolts...
  2. dodson

    Multi-Family Diaphragms

    I have been getting request from both acoustic engineers, architects and developers to allow a break in the diaphragm between party walls on multi-family wood framed buildings. These are typically around 20k sq ft and simple wood framed buildings with interior and exterior shear walls and...
  3. dodson

    Threaded Pipe Tensile Strength

    I have a Timber space truss that is using a combination of steel pipes and rods as the compression and tension members. The contractor wants to use turnbuckles on the rods for erection purposes to be able to rack and plumb the truss, but the architect doesn't like the look of turnbuckles. One...
  4. dodson

    Stainless Grade for High PH in Industrial Wastewater

    I would like to spec a stainless steel column in an industrial wastewater tank. The column would be partially submerged 99% of the time. The water is extremely basic w/ a ph around 10 and has a CaOH content of 700ppm. I am attaching the latest lab report for mineral content in the water. The...
  5. dodson

    Beam Analysis w/ Holes

    I am trying to figure out the best way to determine the stress (bending and shear) in a rectangular beam (not a steel I beam but a wood timber) with a horizontal hole through it. This is the very common situation of plumbing and electrical contractors needing to run lines through a floor system...
  6. dodson

    Below Grade Steel

    I am looking for a good solution to protecting W shapes below grade. They will be supporting a concrete pan deck cantilevered over a cliff as the foundation for a house (NOT the best idea I know!) Most will start about 8' below grade (attached to rock anchors) then eventually be out exposed to...
  7. dodson

    New Mexico Snow Loads

    I'm wondering if anyone has designed anything near Brazos, NM. IBC snow load map shows it is a case study area, but I can't get anyone at the county or the state to give me any information. Any thoughts??

Part and Inventory Search