Search results for query: *

Hello, I am trying to model a pipeline laying on a rigid surface to do some analysis. I have model my rigid surface as 3D analytical rigid. However, when run the analysis the pipeline goes through the rigid surface. How can I make it no to go through and act as a solid ground. Regards,

Hello, I am modelling a pipeline using beam elements and I would like to introduce some strain to the model. I would like to introduce this strain so the pipeline forms a specified radius of curvature. Can anyone help please. Regards,

Hello, Can anybody tell me how to find the maximum curvature of the pipeline during S-laying process. (Sag-bend curvature) regards

Hello, I am using ABAQUS to model a pipe which is fixed at one end and free in the other end. The pipe should undergo rotation and I am not sure how to get the rotation about the axis which is thought the pipe. Regards,

Hello, I am a new ABAQUS user actually I would like to model a pipeline and then use heat gradient to form two bends. I am not sure how to do this. Regards,

Hello, I would like to get some information about pipe roll (rotation of the pipeline when installed subsea) and the ways to prevent it when installing tees or valves. Regards,

Hello, What is the best element type to use in modelling a pipe which undergoes tension, bending and torsion. Regards,

Hi, I trying to apply a pressure on a small section of specimen in the middle and this load is distributed according to an expression in term of position. Should I write the expression a cording to the real x-y-z or abaqus treat the start of the small section as (0,0,0). Please help me

hi I am a new ABAQUS user, I need to apply non-uniform pressure load (function) on a surface.How could I do that? Anybody would please show me the steps to do this. Thanks

hi, I am a new ABAQUS user. I am trying to model a crack in 2D square plate. Could anyone please tell me the steps that I should take to model a crack in the top of a 2D square plate. Thanks,