I have attatched to screen shots of a lifting frame I am working on...
I am struggling on how to fix it?
One screen shot shows it fixed through the lifting hole using a 'Fixed Geometry' fixture and a 'Distributed Mass' on top of the box section
the other screen shot shows it with a 'Fixed...
When calculation the 'stress' of a part... our Company standard is to calculate the stress at 60% of the yeild!
Is there a way of showing this on the chart as well as indicating the 'Yeild strength' which is shown as standard?
Does anybody have any suggestions for using SolidWorks on a Multi-Site set-up so everybody can use the same set of parts from the database?
SolidWorks are pointing our company in the direction of PDMWorks Enterprise! any other suggestions?
If you create a part model complete with dimensions...
when you add a scale to that model, the dimensions stay as the dimensions before the scale!
Is there a way to change the dimensions with the scale?
I want to add a percentage of a figure to a figure...
=SUM(A1+(A1*(40/100)))
If A1 = £10 then the answer would be £14.
but the minimum figure I want to add on is £10, so the answer I require is £20.
Therefore how can I write a statement which would calculate the original sum, but if it was...
How do I round down a number in an increment of 5?
Example:
if I have an aswser of £6.52... how do I round down to £5.00
or
if I have a answer of £21.06... how do I round down to £20.00
I only want to use £5, £10, £15, £20 etc. etc.
I am trying to create a spreadsheet for use when bidding...
I am trying to use the 'FLEX' tool...
I want to apply two flexes to a polyurethane disc representing the disc flexing inside a pipeline.
The problem is the flex tool flexes from the centre point... can you flex about a given radius from the centre point?
Excel 2002
I have a table of threads: M3 down to M10
I am using Index, Match to find specific information from the table relating to the thread for a calculation depending which thread I pick using data validation.
If I have the threads listed in the table from M3 down to M10, the selection...
I am using an IF Statement to work out the cost of something... by doing this, it will work it out to umpteen decimal places (this messes up the spreadsheet to no end) and not the two decimal places required!
Is there a way of adding a ROUND into the equation to get the two decimal places required?
I have managed to construct the 'Wye' in terms of putting two pipes together and putting the relevant holes through!
What I am stuck on is generating the chamfers for the weld preperation... please take a look at the picture attached to see what I require!
Thanks
Has anybody modelled a 'Fabricated Pipeline Wye Piece'?
I am attempting to model one, but am having trouble in getting the cuts of the two pipes correct...
This refers back to an earlier question I posted with regards a 'Dihedral Chamfer'.
I am trying to write an 'IF Statement' where I9 is the variable ranging from 0 to 5000.
R9 and S9 return a different answer depending on the figure I9 returns.
Currently if I9 is '0' R9 and S9 default to 0.20 due to the formula in R9 and S9 respectively.
If I9 is equal to 0 I want I9 to show...
The product I would like to have the 'mass properties' added too, has a wastage of 10%.
Is it possible to add this 10% to the 'overall mass' so this can be shown in the custom properties, and sub sequentially on the drawing?
Is it possible to create a 'Stand Alone Part/Assembly' from a Part/Assembly with configurations without having to delete all of the configurations from the new file...
Doing a Save As replicates the original file complete with configurations.
Note: SolidWorks 2005
