Does anyone remember what the Mil-Spec was (IS?) that controls thread rolling in regard to it being performed BEFORE heat-treat above a certain KSI? I know it's a AS spec now but I need to access the old Mil-Spec for my job purpose of the moment. Thanks!
Hello!
I'm usually in the manufacturing and quality forums but I've run across a personal problem I cannot seem to find the answer to, so I thought I'd run by the motorcyle engineering folks and see what I can obtain.
I have a 2001 Yammie 1100 V-Star classic (Cali model with the AIS)...
Hello all;
I was just posed with what may seem a riduculous question (and it is) but I am required to arrive at an answer THIS MORNING! :O
I on had a lot of (new product, no historical data available) of 3600 units and one was to inspect but 6 of those unit and they were ffound to be...
I've been in the aerospace field for many years and have worked extensively with both decorative anodized finishes and hard anodized working finishes BUT I am now working in a commercial environment and have a problem that I don't have an answer too in regard to anodizing. Is it possible to...
I need to get hold of some reliability tables-based sampling plans. Anyone know of a free, or at least, cheap source for these? I see EVERYONE is eager to sell them to you! :(
Thanks!
Sheep
I need to get hold of some reliability table-based sampling plans. Anyone know of a free, or at least, cheap source for these? I see EVERYONE is eager to sell them to you! :(
Thanks!
Sheep
Working in the aerospace manufacturing fields, I occasionally encounter a drawing that calls out "break feather edge of thread to appx. one half width of thread" on Acme threads. The meaning seems clear to me but I have noticed that it never sems to get done in the places I have worked, with...
