Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. etorrecillas

    Buckling Analysis With Inertia Relief

    Dear fellows, I am writing to ask if anyone has any experience with buckling analysis considering inertia relief effects. I ran some tests with small models to check if buckling modes considering inertia relief effects or SPC approach with fictional body loads should give the same result. It...
  2. etorrecillas

    AL 7050-T7451

    Hi all, I was interested in knowing AL7050-T7451 mechanical properties after being heated to 180°C and cooled again to room temperature. At MMPDS, I found a curve (Fig. 3.7.4.2.1), showed below: At 180°C (356°F), strength is reduced, so I should have care about hot operation, but there is no...
  3. etorrecillas

    Obtaining surface from solid

    Hello guys, Please, I would like to know if is there a way to obtain a surface from a solid. I mean, I have an irregular solid and want to get just its outer face and make it into a surface. I tried the "surface offset", but the resulted surface is dependant on the original solid (if I delete...

Part and Inventory Search

Back
Top Bottom