Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Joshmo
  • Content: Threads
  • Order by date
  1. Joshmo

    Auxilliary Section View Question

    All, this is a simple question so I'm sure it won't strain anyone's brain. I had a discussion with someone at my work this morning about making an auxilliary view not being at the correct projected angle just to make the drawing look nicer. For the case that a tradtional auxilliary view won't...
  2. Joshmo

    RSS correction factor for tolerance stack-up analysis

    All, I came across an equation for a correction factor for RSS tolerance analysis and was wondering if someone here could ellaborate on it for me. I have typically used a 1.5 times the RSS tolerance stack type of adjustment as compared to using a worst case tolerance stack. But, a customer...
  3. Joshmo

    Changing Part units in NX5

    Hello all, I am a new NX5 user and ran into a problem I would think would be simple to figure out but got a little stumped. I made a part in mm but later wanted to swith it and all the dimensions to inches. The only way I found to do this was by using the NX command prompt and typing...
  4. Joshmo

    Assembly Drawing BOM Change Question

    I deleted an item from my assembly drawing BOM for an ECN and have a question. Is it good practice to delete the whole row and item number then shift down everything above it or should I renumber every item? Its an 8 sheet drawing so I hope I don't have to renumber everything. Let me know what...

Part and Inventory Search

Back
Top