Can anyone tell me what the ASME equivalent is of the European standard for investment casting tolerances (VDG P690)?
The abstract of "ASTM A985 / A985M - 04a" seems to indicate that this standard specifies the casting process and inspection requirements. Does this standard also specify the...
I hope this issue was not covered before. I am looking for a standard that outlines the minimum requirements of a drawing in order for it to be acceptable for manufacturing.
I have the following Standards in-house:
-ASME Y14.5M 1994 Dimensioning and Tolerancing
-ASME Y14.24-1999 Types and...
I have a part that can be ordered in a variety of colors (powder coated). The drawing is set up as a tabbed drawing with different versions:
100713-01 = Widget, 2.850 Lng., Powder Coat (Weatherable Silver).
100713-02 = Widget, 2.850 Lng., Powder Coat (Black Wrinkle).
100713-03 = Widget, 2.550...
Sorry if this has been covered before...
I have two steel parts (Aut20 & 18MnCr5) that need to pass a 200 hr salt spray test (ASTM B117). I read that a black oxide finish can withstand 200 hrs of salt spray if the proper sealant is used.
http://www.pfonline.com/articles/pfd0025.html
Is it...
I have been assigned the task of setting up a Document Conrol department. I need to create and SOP and procedures for the control of all of our Engineering documentation.
Does anyone have any good references or standards that I can study? Or at least any suggestions on where to start?
Thanks...
Here is my situation:
We have a part that we would like to have machined by a local fab shop or our overeas plant. These sources can produce large quantities of the basic machined parts at a significantly lower cost than our in house machine shop. However, the secondary operations drastically...
