Hello
I would like to know how much gas will be released in the condition below.
There is a tank of 3 m3 which has a pipe end of 10 mm inside diameter.
In the tank, air is stored at 140 bar.g
I want to know how much air will be released at first when the pipe is cut. In other words, how much...
Hello,
I would like to know how to calculate the situation below.
There is a pipe which have 10 holes having 8 mm diameter.
The pipe is 5 meter long and inside diameter of the pipe is 10mm . The holes on the pipe are evenly devided.
The pipe is located 50 mm high from the bottom of a tank...
Dear all,
I need help.
Given:
1. There are two points. One of them is 1 meter higher than the other.
2. Water goes from the high point to the low point by gravity.
I want to know whether the velocity of the low point is constant or not regardless of the length of two points.
Any help would...
I have a problem. I know that top-flat position of a eccentric reducer is used at a pump suction when the pump is pulling water from a sump. However, I don't know which position of a reducer is correct between top-flat and bottom-flat when a pump is pulling water from a high level, higher than...
