I have a thread that I posted about a GE 3/4 HP condensor fan motor running hot. It was the third motor that had been in the machine. It has run for almost a month but it also failed.The amp draw is fine, the fan blade is right, the capacitor is new, the coil is clean, and all circuits are...
So if you saw my earlyer thread I am having problems with a hydronic system getting clogged with solids. I got a lot of good advice and now I think I have a handle on what is causing my problem. The second company who tested the feed water said it was to hard and also had a little bit of iron in...
I Have a system that is called a reheat hydronic system for building heating and cooling. It has a Laars 1million BTU boiler with a boiler loop pump. This drops onto a large loop with one grundfoss pump. The building has small coils throughout that heat air to diferant zones as needed. The...
I have heard that GE moter that are made by Regail-Beloit are not very high quality. I have had a new GE like this fail. I got the information from a rep from ICM. Just want to know what others have seen out there. Thanks
I have a 2/4 HP. GE motor that is part of a York commercial air conditioner. it runs the prop fan for the condensor. It is a sealed case motor with sealed berings. 208-230 1 ph with a 10/370 run cap. Insulation class B. This is a new motor. I am reading 190 deg F on the outside of the case with...
I have a small ge moter in a packedge heat pump that is running 190 F. This is the third moter in this unit. Its a 230 volt single phase condensor fan moter. checked and double checked every conection. Amp draw is 3.7 and the name plate rates the RLA at 4.8. This seems way to hot. Also GE has a...
