Hi,
I'm designing a gas heater in which a salt bath is heated by 2, 650mm OD fire tubes. These fire tubes are conected to a burner at one end, which delivers a 2.5m long flame with 750mm in diam, 1.6E6 Kcal/h and which has 2000°C at its hotest point (inside feather). For protecting the fire...
According to a senior design eng of our firm, the correct material for this vessel (design temp= 100/-128 °C) is SA240 TP304L.
According to ASME Secc 2D (Metallurgical Phenomena), the only materials which do not show a decrease in the tensile yield nor ductility measured as percent elongation...
Hi,
Does anyone know of any software for simulating rigid body movement?? I'm looking for a software to model rigid bodies as bars with specified inertia properties and relative constraints. I wouldn't like to draw the assembly like for example when using SolidWorks.
I used Matlab...
Hi,
I had a discussion with my collegue at work because he thinks that the nozzles attached to an elliptical head must be placed inside a circle of diam = 0.8 Head's OD.
Refering to the ASME code UG-37, I only found that in case the nozzles (with their reinf pad) are included in a 0.8*(Head's...
