Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: kklinger
  • Content: Threads
  • Order by date
  1. kklinger

    weld symbols in drawings

    In response to closed thread554-210324. To remove the weld sequence # from the reference tail on a weld symbol created with Pro/Weld, you need edit the weld symbol and remove the reference text from the symbol. To edit a weld symbol, from a drawing, go to format->symbol gallery->redefine and...
  2. kklinger

    Hydraulic Cylinder Rotation

    Group, I am looking for ideas. We are trying to qualify a replacement hydraulic cylinder from a new cylinder manufacturer. During cycling of the new cylinder, the cylinder rod rotates which leads to loosening of threaded connections. The new cylinder manufacturer does not have a much, if any...
  3. kklinger

    Sheave Stress

    Sorry if this information was presented in a previous thread, but I did not find the information I was looking for. I have a ductile iron sheave that rotates about a shaft which is used to redirect wire rope. The sheave consists of a center hub, 6 spokes (arms) evenly spaced about the...
  4. kklinger

    Direct Shear vs. Moment Load

    I have a pinned joint where one part can rotate about a pin fixed on one end (cantilever). The pin is 1" diameter and the gap between parts is approx. .1". I know that if there was zero gap between the two parts, I could treat the loading on the pin as direct shear (similar to a bolted...
  5. kklinger

    Design Equations for Sheaves using Wire Rope

    Does anybody know the equations for calculating stresses in a sheave? I know the P=2*T/D*d equation for sizing a sheave diameter for the wire rope. I have what I believe is a single piece steel rim pulley and for use at low speeds. TIA kklinger
  6. kklinger

    Can hardened 1144 Stressproof or 4140 ASTM A193 B7 be crackless

    Hello group, I am specifying 2" bar 1144 Stressproof to be induction hardended to Rockwell C 45-55 at case depth of 0.060"-0.080". As an alternate material, I specify 4140 ASTM A193 B7 with the same hardness requirements. Can either of these two materials be supplied without visual and...
  7. kklinger

    Statically Indeterminate Problem

    Does anyone know of a good book on Statically Indeterminate Problems? If you go to Amazon.com, it will list 30 books with little or no detail about them. I am looking to verify my reactions that I obtained using FEA. I tried using the 3 Moment equation with a little bit of success. My...
  8. kklinger

    how do I switch windows?

    I am running an internal plug-in for AutoCAD 2000. When the application is finished, it activates a dialogue box or message box with an okay button. I would like to be able to switch to this dialogue box and close it by either clicking the ok button using vba code for AutoCAD 2000 or closing...
  9. kklinger

    Lightning Reference Handbook

    Does anybody know where I can obtain new copies of the Fluid Power Designers' Lightning Reference Handbook? Is this book no longer in print?
  10. kklinger

    Friction Factors and Resistant Coefficients

    I am trying to calculate the pressure drop in a hydraulic manifold. Does anybody know the friction factor for a machined hole (using a hss twist drill)? All the information I found so far is for pipe. Does anybody have resistance coefficients for intersecting holes whose axis are offset (don't...

Part and Inventory Search

Back
Top