Hey all,
I'm looking at an idea for a step-up transmission with a ratio around 30:1 - 50:1. The input speed (the low-speed side) is slow, about 100 RPM. The torque required is about 500 inch-pounds, fluctuating (and reversing). Because of the reversing torque, the transmission would need to...
Hello all,
I'm working on a new design (for my company, that is) of a small wheeled carriage that rolls along the bottom of a 1018 steel bar. I would like to use magnets to hold the carriage to the bar.
The bar is 1" wide, .1875" thick, and several feet long.
I need to maintain an air gap of...
I am working on a small bearing application (20mm shaft) where the load is primarily radial, with a very small amount of overturning moment. There's not much axial space to work with, and the main candidates in my design are currently a deep-groove ball or needle-roller bearing with a thrust...
