Does anyone know where I can get fuel properties for diesel fuel number 2?
I'm trying to model a valve in Floworks and need the density, dynamic viscosity, specific heat (Cp), and thermal conductivity.
Thanks,
Dummi
Hi,
I'm reviewing a report where they are trying to determine the max gap between two plates in contact.
They use the equation (F1 + F2)/2 = Maxgap. Where, F1 and F2 are the flatness of the two plates.
Does this make sense to anyone? Do things change if there is a force pressing these two...
Hello,
I have a straight-threaded barrel going through a cover plate, and I need to have IP56 ingress protection.
Does anyone have any experience sealing on straight threads? Will it be enough to just put some teflon tape on the threads? I'm trying to stay away from pipe dope, because I'm...
Hello,
I have a straight-threaded barrel going through a cover plate, and I need to have IP56 ingress protection.
Does anyone have any experience sealing on straight threads? Will it be enough to just put some teflon tape on the threads? I'm trying to stay away from pipe dope, because I'm...
Hi,
I'm trying to calculate K using Cp and the equation K=Cp /(Cp-R).
I looked up Cp in the JANAF tables and in a CRC book and the Cp values were listed at 100 KPa. I'm trying to find K at STP does it matter that Cp is taken at 100 and not 101 KPa? How do I convert it or find it at standard...
Hi all,
I'm an engineer fresh out of college and I'm doing some design work.
I need to figure out if the ABMA standard for locknuts is sufficient for my application of it or if I need a hardened nut.
The standard that this locknut is going by is that it has to have a tensile strength of...
hi guys,
i'm new to these forums but you guys seem to really know your stuff.
anyways, i have this problem. i have this nut that is supposed to lock down this bearing. and the bearing is supposed to be locked down with say 15 lbs of force. how do i calculate how much torque is needed to...
