Hello All,
I hope you can guide me on my way to find an answer. I need to calculate if a separator is going to rupture due to fire exposure. I estimated the temperature profile through time. I think I have to calculate the strength on the vessel to compare it with the UTS of carbon steel at...
Hello All,
Please do you know how to calculate the mean metal temperature? I need it to determine the design temperature of the flare piping dowstream of the BDV/RO in case of depressurisation.
Thanks in advance,
Petroleo
Hello All,
I hope any of you can help on this. I need to calculate the shear rate in a pipeline at different flowrates of a mixture of gas and oil. I have read that I need the internal diameter of the pipeline, and velocities but I am not clear about the equation and if the velocities are for...
Hello All,
I have this info about an oil cooler:
Size: 2.58ID 23 O/L
Design T:120 S:155F & T:150 S:250 psig
Oper. T:45/70 S:128/75F & T:100 S:186 psig
It means, shell and tube type, but I need to know if it cah handle around 30 MBOPD? I think oil is flowing through tubes.
Thanks in advance...
Hello All,
I suppose this is a so simple question but I am afraid I do not know how to solve it. Could you tell me How I can calculate if the residence time in an existinting horizontal separator is OK? I have the dimensions and estimated liquid and gas flows.
Thanks in advance,
Petroleo
Hello All,
Do you think it is possible to switch a conventional 1st stage separator with an electrical oil dehydrator? the dehydrator is 6 times bigger but I do not find technical information about its limitations. I mean what is the main characteristic of this type of vessel? The only info I...
Hello All,
I am reading a Topside Weight Review and I need to know the weight for each piece of equipment. But only base dry weight / base operational weight ratios for 10000t topsides are reported. DO you know what is that? how can I use them to get what I need?
Regards,
Petroleo
Hello everybody,
I am wondering what would be a suitable maximum segment size for a pipeline pressure drop calculation with pipesim package? is a 3% of the pipeline length a good criteria?
Thanks,
petroleo
Hello all,
I think when liquid rate increases, BHP should increase as well. The opposite behaviour could be seen when GOR or gas Lift increases, or when water cut decreases, isn't it?. But I am simulating several 12000-15000 ft depth wells, 30API and I am getting lower BHPs at higher liquid...
Dear Colleague,
I am looking for information in how to control water production. I have read a little bit of gel injection, a polymer that change the relative permeability in the reservoir allowing oil and gas to be produce, and blocking water, but beside that, I would like to know if you have...
