I have a 250PFC hot rolled channel member that is cast into a large reinforced concrete (RC) wall . Thus a fixed member with a point load at the end. Does anyone know how to calculate the development length of the section into the rc wall?
thanks in advance
________________________________
Use...
I am currently designing a 11 storey residential apartment building. I have a 2 way rc "end span" slab restrained on all 4 edges with 400x 600dp beams. Beams are spaced at grids of 7.8m & 8.1m. Data as follows:
LL = 2 kPa
SDL = 3.0 kPa (inclusive of 150 series NLB blockwalls)
DL = Slab self...
Could anyone please provide some help on how to differentiate the above two Structural systems for high seismic regions? My building is 11 storeys high, half of which sits into a hillside. I have weathered rock on all pad footings with allowable bearing pressure of 600-1000 kPa. I am having...
I have to come up with a prelim design of a 250 meter long retaining wall. Before answering this question i would like everyone to know the wall is to be built in a developing country with a very low budget. Details as follows:
- height of wall is 2.5m maximum
- uphill slope = 0 degrees
-...
Iam currently designing a 10 storey reinforced concrete building to be located in a highly active seismic zone with around 0.35g. Today iam looking closely at a RC transverse beam loaded with a structural 200 series blockwall above it at the carpark on the 2nd floor. The client wants to maximise...
Im new to this forum so excuse my question if someone has asked the same.
I understand DCP results undertaken for a simple building structure for example a 3 storey RC building can be deduced to obtain Allowable Bearing Capacity (kPa). Can someone tell me exactly how this can be obtained. What...
