Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: jjl317
  • Content: Threads
  • Order by date
  1. jjl317

    Aluminum Design - Unbraced unequal leg angles in bending

    I am working through the US based Aluminum Design Manual ADM (using 2015 version, though not sure if this section has changed much over the various versions) to determine the allowable bending moments for unbraced unequal leg angles. The ADM does include a number of worked out examples...
  2. jjl317

    Equivalent "Responsible Charge" requirements in Canada?

    Do the various provincial P. Eng rules in Canada include anything similar to the more specific "responsible charge" requirements used by many US states, where the engineer stamping the project must be in charge of the development of the drawings, calculations, etc. ? I know each state is...
  3. jjl317

    Screws into face of plywood

    I have an application (light exterior stone cladding) that the design team had decided should be attached to a plywood substrate. Does anyone know of a good product that can be used to screw stainless clips to plywood (preferably with an ESR report, or at least good technical data)? I was hoping...
  4. jjl317

    ACI Post installed Anchorage - Effective Minimum Safety Factors

    Greetings all - I am trying to appease a reviewer on a project, who is apparently unfamiliar with ACI318-11 Appendix D "Anchoring to Concrete", and it's use with post installed anchors. The specification on the project (dated 5/2017) still reference the old "4:1 minimum safety factor against...

Part and Inventory Search

Back
Top